Hydraulic brake unit failure. yes part is still available for inspection as it is still n the vehicle. I was driving to work at 21:30 hours on 1/1/2025 on a snow covered road. I gently applied the brakes and my truck went into a spin. I was going 25 mph. the abs unit failed and there was no pulsating in the brake pedal and rear brakes locked up sending the truck into an uncontrollable spin. my front left driver side of the vehicle then struck the jersey barrier and vehicle did continue to spin and then struck passenger rear side of the vehicle on the jersey barrier. currently has $17k in damages to the vehicle. I was not injured at the time but currently experiencing lower back pain. there was no lights or warnings on dash until immediately after the collision. I had the ABS HBU replaced a few months back and was told the new unit was part of the old stock and would most likely fail. which it did. unfortunately i am one of the people in this world who could not afford to not drive my vehicle as the truck was $70k new and i still am currently driving it due to not being able to afford to replace it of park it and rent a vehicle. The HBU has been a known issue in these trucks for the passed year and they just issued a recall on 12/08/2024. this problem was first noticed on 05/08/2024. was taken to dealer shortly afterward and was told that these are known to fail and currently no remedy to the issue. as of 01/07/2025 there is still no remedy or time on when parts are available for replacement.