the issues I’m experiencing are a rubbing sound when breaking and turing the wheel. THE CAR TURNED ON AND COULD NOT BE TURNED OFF. nothing worked or responded no matter what you pushed. The brake sensor and lane assist diagnostic fault codes (error codes)popped up which they couldn’t find a bulletin or error code to replicate the issue. The vehicle would not read the key fob, it would say the fob had left the vehicle because the door opened, or if i move the key while in the vehicle( bulletin for this issue). I get the call that my vehicle is ready and I’m driving away and the steering wheel vibration coming from the engine between 40 and 49mph feels like I should be driving on rumble strips, but the drive is smooth, this is coming straight from the engine or transmission when you accelerate through the steering wheel. This was not an issue before they ran their tests and fixed said problems. The computers are still updating on the screen and I hope that it evens out when the car turns on and off and the computers reset.NOW TODAY the car starts dinging and error codes are flashing on my dash. It’s the lane sensor and the lane assist error code going crazy. This was the issue they couldn’t replicate or find a bulletin on. Here’s the fun part, the problem becomes more consistent when I apply the brakes. One time the brakes seem to not work properly. All these error codes pop up when you initiate the braking system. Then the final error code was warning me that the breaking system was faulty. I drove it straight to the dealership and left out with them again.