Just over 1 week ago, I was leaving a parking lot and driving back to my home when my car wouldn’t accelerate past about ~10-15 miles per hour and wasn’t shifting gears. When I took my foot off the gas pedal, the gear just dropped immediately from above third to first gear and the car shook. I first noticed this when already out of the parking lot and pulling off from a median onto the road, with no engine light or other warnings. I quickly pulled into the turn lane where there wasn’t traffic and turned the car off and back on. It was the same but luckily I was in eyes view of my apartment, so I drove under 10 mph and made it home. I took the vehicle to a transmission service center and the error code that came up on the computer was (P0500 – Vehicle Speed Sensor A), which the service center said is an issue with the ‘valve body’ inside the transmission, specifically the ‘TCM – Transmission Control Module’ that sits on top of the valve body. I contacted multiple Infiniti service centers and they all confirmed that the valve body for my vehicle (part# 31705-x133a) is back ordered by over a month and could be longer until they have it. They do not sell the Transmission Control Module separately. The valve body was quoted to me for $2200 for the part alone. I attempted to install an aftermarket valve body and a new error code came up on the computer (PO720 – Output Speed Sensor Circuit). I kept the original valve body and will hold onto it. Doing some more research, this appears to be a common issue with the Infiniti Q50 – [XXX] In addition to the reddit thread above, a quick google search for Infiniti Error codes P0500 and PO720 point to multiple sources indicating the same common experience and outcome. My vehicle has 110k miles and users in the reddit comments are also reporting the same issue with the TCM Transmission Control Module occurring between 85k – 100k miles in all cases. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)