While sitting at an intersection of a busy 4 lane road the engine stoped without warning and could not be restarted. Due to a poor design by GM, the Tah has no ability to be put in neutral when the engine isnt running. We were stuck at a busy intersection an almost hit multiple times, until a tow truck could come since it cannot be put in neutral and pushed. Dealer inspected engine and found it had been burning oil. The car never gave any warning lights that it was low on oil or that there were any engine issues. They did an oil change and gave the car back. The car was running, but within less than 5 miles of driving it it started to shake and make horrible noises. At this point, I was driving on the interstate. I was able to limp the vehicle back to the dealer. It was diagnosed by a dealer with spun engine bearing. I was told they were very close to seizing up and I wouldve been stranded on the interstate with no shoulder. This couldve caused a major issue as I was on a busy interstate and the vehicle wouldve locked up. There was no shoulder at this point due to construction. Through both of these issues the vehicle never gave any dashboard warning lights. There are two major design flaws. The engine has an issue with its bearings. Also, there needs to be a way to put the vehicle into neutral while the engine is not running. It is not safe to not be able to put these vehicles into neutral.